Re: Appletalk on an ATM Interface

From: John Galt Kupec (jkupec2@xxxxxxxxxx)
Date: Thu Aug 19 1999 - 10:32:40 GMT-3

Next message: Jason Aarons: "ATM: LANE Client config sample"
Previous message: George Harizanov: "Re: CPU time"
Maybe in reply to: Mark S. Detrick: "Appletalk on an ATM Interface"
Next in thread: Mark, Detrick: "Re: Appletalk on an ATM Interface"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

"Mark S. Detrick" wrote:
>
> I have a 3640 with an ATM interface. I have apple routing turned on and on
> the interface I have apple cable-range 1-1 and apple zone ATM. Then I do sh
> apple route. I should see the connected interfaces, I see all EXCEPT the
> ATM interface.
>
> Why won't AT show up as connected route for an ATM interface? What am I
> missing?

Is your ATM interface connected to anything? Typically, AT won't show a
route if the interface hasn't talked with another AT interface on the
same network.

"show apple int" might report something like:

AppleTalk address is 1.94, Invalid

HTH

--
John Galt Kupec       CCIE #4837
jkupec@ccci.com       http://www.ccci.com
----------------------------------------------------------------------

Next message: Jason Aarons: "ATM: LANE Client config sample"
Previous message: George Harizanov: "Re: CPU time"
Maybe in reply to: Mark S. Detrick: "Appletalk on an ATM Interface"
Next in thread: Mark, Detrick: "Re: Appletalk on an ATM Interface"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:47 GMT-3