Re: DLSW Mesh without border peers

From: kongck (kongck@xxxxxxxxxxxxxx)
Date: Sat Nov 13 1999 - 10:11:06 GMT-3

• Next message: Eddie M. Parra: "DECnet IV - V conversion Config - Pleas help..."
• Previous message: Robert Hales: "DLSW Mesh without border peers"
• Maybe in reply to: Robert Hales: "DLSW Mesh without border peers"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
you can make dlsw peer between R1 and R3 if it is
permitted.

--- Robert Hales <rhales@cisco.com> wrote:
>
> Is there a way of getting a full mesh without using
> border peers. Such that when the PC on R1 sends out
> a NetBios packet R3 sees it?
>
> R1 - R2 - R3
>
> It works fine with border peers but I dont know if
> this is the only way?
>
> TAI
>
> Rob
>
>
>

• Next message: Eddie M. Parra: "DECnet IV - V conversion Config - Pleas help..."
• Previous message: Robert Hales: "DLSW Mesh without border peers"
• Maybe in reply to: Robert Hales: "DLSW Mesh without border peers"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:55 GMT-3