From: Muralidhar Devarasetty (dhar_murali@xxxxxxxxxxx)
Date: Fri Feb 04 2000 - 14:29:47 GMT-3
U require to use opposite logic.Clear all the VLAN from that trunk except
which U want to pass.
Try this.
Murali
----Original Message Follows----
From: "Ben Rife" <brife@bignet.net>
Reply-To: "Ben Rife" <brife@bignet.net>
To: <ccielab@groupstudy.com>
Subject: CAT5K Trunking
Date: Wed, 2 Feb 2000 16:35:06 -0500
Hey guys,
I'd like to configure a trunk 1/1 so that it will carry only traffic on
VLAN4 and VLAN1.
I entered the following on my switch:
Console> (enable) set trunk 1/1 1,4
Port 1/1 allowed vlans modified to 1-1000
Why does it say 1-1000? Why not 1,4?
Thanks,
Ben
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:22:52 GMT-3