From: Rob Ehlers (ccieorbust@xxxxxxxxxxxxxxxxxxx)
Date: Mon Mar 06 2000 - 16:51:32 GMT-3
well, one of the questions on the FAQ states that you will not have to
configure a LS1010... but you need something to connect the ATm interfaces
to.. I have a LS100.. which is funky from what I understand...but it
should work... I guess. <grin>
On Mon, 6 Mar 2000, ejobson wrote:
> In the lab cisco seem to indicate that 2500, 4000 and cat 5000/5500 are the
> standard pieces of kit used. Are the ATM lab questions only related to these
> bits of kit or is it necessary to get access to an ls1010 before attempting
> the lab.
>
> Eddie Jobson (UK)
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> Rob Ehlers
> Sent: Friday, March 03, 2000 2:34 AM
> To: CCIELAB
> Subject: Re: LANE and ATM
>
>
> Well, you can issue the commands on the card, but there isn't much way to
> test it, unless you have some kind of ATM switch inbetween. An old
> lightstream 100 would do, if you can find out. You can put a loopback on
> the ATM interface to get it UP,UP... I guess you could run some debug
> commands to see if it performing correctly after that.
>
> On Thu, 2 Mar 2000 josh@mstates.com wrote:
>
> > Is it possible to configure LANE without a LS1010 in the configuration or
> > must you have a LS1010 to complete?
> >
> > Josh
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:04 GMT-3