From: Asbjorn Hojmark (Asbjorn@xxxxxxxxxxx)
Date: Sun Apr 02 2000 - 18:39:33 GMT-3
> Is it possible to bridge over a gre tunnel?
Yes, but it isn't supported.
> The "bridge_group" command is not listed under the interface.
It's hidden:
T4000#conf t
Enter configuration commands, one per line. End with CNTL/Z.
T4000(config)#int tun123
T4000(config-if)#bridge-g 123
% This command is an unreleased and unsupported feature
I've tested it a few months ago and it worked fine. I ended up
using IRB, however, because it isn't supported. (And it was later
changed to DLSw because IRB doesn't support ISDN).
-A
-- Heroes: Vint Cerf & Bob Kahn, Leonard Kleinrock, Robert Metcalfe Links : http://www.hojmark.org/networking/
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:12 GMT-3