From: Jay Hennigan (jay@xxxxxxxx)
Date: Tue Apr 04 2000 - 03:05:21 GMT-3
On Mon, 3 Apr 2000, Michael Bausenwein wrote:
> I have a couple of configs attached that i setup in a lab environment.
> There are 2 routers a 4700 and a 7507. Each one has 2 sub interfaces. On
> one sub interface the 4700 is the ARP server and on the other the 7505 is
> the arp server.
>
>
> To configure the arp server use the atm arp-server self command.
>
> to configure the remote to point to the atm-arp server use the arp-server
> nsap command
>
>
> Get the nsap of the Arp server by doing a show atm ilmi or show atm ilmi
> status. ( included them at the bottom of the config, so you can tell which
> witch is which :>)
Thanks, this is a great help.
One question, in the config
!
interface ATM0.50 multipoint
ip address 50.1.1.1 255.255.255.0
no ip route-cache
atm arp-server nsap 47.009181000000001007380701.00100B4DF020.50
atm esi-address 111111111111.50
!
Where does the .00100B4DF020.50 number at the end of the NSAP come from?
It isn't shown in the ilmi-status data.
Active Prefix(s) :
47.0091.8100.0000.0090.5f57.5701
End-System Registered Address(s) :
47.0091.8100.0000.0090.5f57.5701.1111.1111.1111.50(Confirmed)
47.0091.8100.0000.0090.5f57.5701.00e0.1ece.3f29.30(Confirmed)
Thanks!
-- Jay Hennigan - Network Administration - jay@west.net NetLojix Communications, Inc. NASDAQ: NETX - http://www.netlojix.com/ WestNet: Connecting you to the planet. 805 884-6323
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:12 GMT-3