From: Simon Baxter (Simon.Baxter@xxxxxxxxxxxxxx)
Date: Mon Jul 31 2000 - 01:11:47 GMT-3
As per the CD :
By default, the clients of a route reflector are not required to be fully
meshed and the routes from a client are reflected to other clients. However,
if the clients are fully meshed, the route reflector does not need to
reflect routes to clients. To disable client-to-client route reflection, use
the following command in router configuration mode:
Command Purpose
no bgp client-to-client reflection Disable client-to-client route
reflection.
-----Original Message-----
From: Padhu@steinroe.com [mailto:Padhu@steinroe.com]
Sent: Monday, July 31, 2000 2:04 PM
To: ccielab@groupstudy.com
Subject: BGP - Route Reflectors in a peer group related question
>From Hallabi's book page 422-423 ..
Can someone clarify why on page 423 exists in the same router config ?
router bgp 3
neighbor clients route-reflector-client
no bgp client-to-client reflection
Aren't these two commands negate each other ? Appreciate any inputs .
Thanks .
Cheers,Padhu
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:59 GMT-3