From: Kenneth Sacca (ksacca@xxxxxxxxx)
Date: Tue Aug 15 2000 - 18:04:08 GMT-3
Yes with a channelized T1 or T3 interface.
interface serial0:0
encapsulation x25
interface serial0:1
encapsulation frame-relay
Here is an x25 SVC setup.
Regards Ken
Router 1:
no ip routing
!
interface serial0
no ip mroute-cache
no ip route-cache
ip address 1.0.0.1 255.0.0.0
encapsulation x25
x25 address 170091
x25 map ip 1.0.0.4 170094
Router 2:
no ip routing
x25 routing
!
interface serial4/0
no ip address
no ip mroute-cache
no ip route-cache
encapsulation x25 dce
x25 address 170092
x25 nvc 8
clock rate 64000
!
interface serial4/1
no ip address
no ip mroute-cache
no ip route-cache
encapsulation x25 dce
x25 address 170093
x25 nvc 8
clock rate 64000
!
x25 route 170091 interface serial4/0
x25 route 170094 interface serial4/1
Router 3:
no ip routing
!
interface serial0
no ip route-cache
no ip mroute-cache
ip address 1.0.0.4 255.0.0.0
encapsulation x25
x25 address 170094
x25 map ip 1.0.0.1 170091
Harbir Kohli wrote:
>
> Hello Group,
>
> Can you configure a Cisco Router to switch both X.25 and Frame out the
> same interface ?
> I would think not, but does anyone know for sure ?
>
> Does anyone have a sample config for an X.25 switch ? (SVC's not PVCs)
>
> Harbir
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:26 GMT-3