From: mark salmon (masalmon@xxxxxxxxx)
Date: Sun Sep 10 2000 - 18:34:43 GMT-3
Yep. however, I had to use an access list at the end as I received an
incomplete command error. I then created a standard access list (
acess-list 1 permit any), and it stil did not work.
To test it I configured a IP network on a loopback interface on one of
the EIGRP enabled router. I then used the command default information
out under the EIGRP process.
On one of the other routers I placed a default informatiion in command.
I then tried to ping the loopback interface of the original router. I
was unsuccessful.
Sam Munzani wrote:
>
> EIGRP is supposed to understand "ip default network" command. However I have
> not tested it. As a matter of fact I could not make it work any way.
>
> I have not played with it but do you know the result of following command?
>
> Router eigrp 1
> default-information out ?
>
> Sam
--Mark Salmon Cisco Systems Inc Phone:773-695-8235 Pager:800-365-4578 email: masalmon@cisco.com Empowering The Internet Generation.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:54 GMT-3