From: D. J. Jones (meganac@xxxxxxxx)
Date: Sun Sep 10 2000 - 21:26:36 GMT-3
Have not done it on a 36xx but did it on a 2621 using dot1q and 4003
switch..dj
Set up two trunks on the 4003 to support dual 2621s running hsrp. Used IOS
12.1.1. Hope this helps..dj
----- Original Message -----
From: "Mark Salmon" <masalmon@cisco.com>
To: "Sam Munzani" <sam@munzani.com>; <ccielab@groupstudy.com>
Sent: Thursday, September 07, 2000 6:33 PM
Subject: Re: Inter Vlan routing and 36xx
> No as I said, e? only showed the exit option.
>
>
> At 12:07 AM 09/07/2000 -0500, Sam Munzani wrote:
> >Do you an option for encap SDE?
> >
> >Sam
> >----- Original Message -----
> >From: "mark salmon" <masalmon@cisco.com>
> >To: <ccielab@groupstudy.com>
> >Sent: Thursday, September 07, 2000 1:05 AM
> >Subject: Re: Inter Vlan routing and 36xx
> >
> >
> >> Thanks to all who responded. Apparently I was not clear enough. Here
is
> >> what I did:
> >>
> >> In config mode I did
> >>
> >> int fast 0/1.1
> >>
> >> In sub interface mode I did e? and all I saw was exit.
> >>
> >> What I asked was did anyone on the list successfully configured inter
> >> vlan routing on a 3600 series router as I was unable to find
information
> >> in the documentation relating to a 3600 router.
> >>
> >> I am aware that 7xxx router supports inter vlan routing in fast/gig
> >> interfaces.
> >>
> >> Is there someone out there who was able to do it on a 3600 series
> >> router?
> >>
> >>
> >>
> >> Sam Munzani wrote:
> >> >
> >> > You have to do following.
> >> > If your fastEthernet interface is 1/1 then,
> >> >
> >> > int fast 1/1.1
> >> > encap isl 1 <== Where 1 is VLAN number for the trunk.
> >> >
> >> > You can't do trunk on main interface.
> >> >
> >> > Sam
> >> > ----- Original Message -----
> >> > From: "mark salmon" <masalmon@cisco.com>
> >> > To: <ccielab@groupstudy.com>
> >> > Sent: Wednesday, September 06, 2000 11:26 PM
> >> > Subject: Inter Vlan routing and 36xx
> >> >
> >> > > Has anyone been able to do inter vlan routin between a cat switch
and
> >a
> >> > > 36xx router with fast eth interfaces? I tried and the one I am
using
> >> > > (on Vlabs by mentor labs) there is no encap isl command available.
> >> > > --
> >> > >
> >> > >
> >> > >
> >> > > Mark Salmon
> >> > > Cisco Systems Inc
> >> > > Phone:773-695-8235
> >> > > Pager:800-365-4578
> >> > > email: masalmon@cisco.com
> >> > > Empowering The Internet Generation.
> >> > >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:54 GMT-3