From: Joe Pinkus (jpinkus@xxxxxxxxx)
Date: Tue Oct 17 2000 - 09:09:52 GMT-3
Dave,
Two things to check:
1. When phone on R1 calls R2 what type of ring back do you hear?
2. Look at the output of show voice port when the phones are off hook, looking
for the status of the operation state, dormant means on hook, active means off
hook.
This is to just verify that you have the phones connected to the right voice
ports. The ports are numbered right to left.
Joe
dave.awatere@equant.com wrote:
> Can't get the phone to ring. Call connects OK but the phone does not ring.
I
> have tried the handsets in wall outlets and they ring just fine.
> I also tried changing the ring frequency from 25-50 but still no go. Anyone
> else seen this prob?
>
> Cheers\Davo
>
> Handset------FXS2/0/0___r1-------------r2___FXS2/0/0------Handset
>
> Current configuration:
> !
> hostname r1
> !
> interface FastEthernet0/0
> ip address 1.1.1.1 255.0.0.0
> !
> voice-port 2/0/0
> cptone NZ
> !
> voice-port 2/0/1
> cptone NZ
> !
> dial-peer voice 1 pots
> destination-pattern 1000
> port 2/0/0
> !
> dial-peer voice 2 voip
> destination-pattern 9...
> session target ipv4:1.1.1.2
> !
> end
>
> Current configuration:
> !
> hostname r2
> !
> interface FastEthernet0/0
> ip address 1.1.1.2 255.0.0.0
> !
> voice-port 2/0/0
> cptone NZ
> !
> voice-port 2/0/1
> !
> dial-peer voice 1 pots
> destination-pattern 9000
> port 2/0/0
> !
> dial-peer voice 2 voip
> destination-pattern 1...
> session target ipv4:1.1.1.1
> !
> end
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:27 GMT-3