From: Forest Riek (forestr@xxxxxxx)
Date: Fri Oct 27 2000 - 22:20:45 GMT-3
Hi,
I would change to configure as follows:
add at the global level:
source-bridge ring-group 200
bridge 1 protocol ieee
interface TokenRing0
no ip address
ring-speed 16
source-bridge active 100 1 200
source-bridge spanning 1
multiring all
interface TokenRing1
no ip address
ring-speed 16
source-bridge active 300 1 200
source-bridge spanning 1
multiring all
I hope this helps.
Forest
radha rani wrote:
> Hello,
> I have a very simple SRB configuration which is not working. I
> would be very grateful if someone could shed some light on this.
>
> My topology is :
>
> r1 --- ring100---r4---ring300---r3
>
> r1 and r3 are acting as hosts and have ip addresses 10.10.1.1/24 and
> 10.10.1.3/24 resp. r4 is the source-route-bridge. I am unable to ping
> r1 and r3 from each other.
>
> Thanks for your help.
>
> R4's config is as follows:
>
> r4#sh run
> Building configuration...
>
> Current configuration:
> !
> version 11.2
> no service password-encrypt
> no service udp-small-server
> no service tcp-small-server
> !
> hostname r4
> !
> !
> !
> interface Serial0
> no ip address
> shutdown
> !
> interface Serial1
> no ip address
> shutdown
> !
> interface TokenRing0
> no ip address
> ring-speed 16
> source-bridge 100 1 300
> !
> interface TokenRing1
> no ip address
> ring-speed 16
> source-bridge 300 1 100
> !
> no ip classless
> !
> !
> line con 0
> line aux 0
> line vty 0 4
> login
> !
> end
>
> r4#
>
> -Radha
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:31 GMT-3