From: Sam Munzani (sam@xxxxxxxxxxx)
Date: Fri Nov 03 2000 - 17:13:36 GMT-3
Here is a section from document CD.
To configure more than one secondary network, repeat as appropriate. See
Table 8 for a list of encapsulation types you can use on IEEE interfaces.
----------------------------------------------------------------------------
---- Note When enabling NLSP and configuring multiple encapsulations on the same physical LAN interface, you must use subinterfaces. You cannot use secondary networks. ---------------------------------------------------------------------------- ----> I can't seem to redistribute the secondary network into NLSP. Is this not > possible? > > > >From: "Sam Munzani" <sam@munzani.com> > >Reply-To: "Sam Munzani" <sam@munzani.com> > >To: "mark salmon" <masalmon@cisco.com>, "Scott Morris" > ><smorris@mentortech.com> > >CC: <ccielab@groupstudy.com> > >Subject: Re: IPX - multiple frame encapsulations on one wire > >Date: Fri, 3 Nov 2000 13:08:39 -0600 > > > >I prefer subinterface because that's easy, works with NLSP as well. What if > >you are told not to use subinterface in lab? Give brain a little excercise. > > > >Sam > > > > > > > Update. With future releases, IPX secondary addresses will not be > > > supported. Practice using sub interfaces instead. Trust me. > > > > > > Scott Morris wrote: > > > > > > > > (config-if)ipx network (net) encapsulation (encap-type) secondary > > > > > > > > Enjoy! > > > > > > > > Scott Morris, MCSE, CNE(3.x), CCDP (R&S), CCIE (R&S) #4713, Security > > > > Specialization, CCNA - WAN Switching > > > > CCSI #21903 > > > > smorris@mentortech.com > > > > > > -- > > > > > > > > > > > > Mark Salmon > > > Network Support Engineer - SBC OP HQ > > > Cisco Systems Inc > > > 8735 W. Higgins Road Suite 300 > > > Chicago IL 60631 > > > Phone:773-695-8235 > > > Pager:800-365-4578 > > > email: masalmon@cisco.com > > > Empowering The Internet Generation. > > >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:41 GMT-3