RE: IPX RIP - Can't see a remote site

From: Steve McNutt (lpd@xxxxxxxxxxxxxxxx)
Date: Tue Nov 07 2000 - 01:57:41 GMT-3

• Next message: Jack Heney: "IPSec Dynamic---Configs"
• Previous message: zhangxianqi: "ospf redis"
• Maybe in reply to: Ronnie Royston: "IPX RIP - Can't see a remote site"
• Next in thread: Jack Heney: "Re: IPX RIP - Can't see a remote site"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
can't turn off split horizon for IPX RIP. gotta use a different IPX routing
protocol on your frame or run fully meshed tunnels.

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Ronnie Royston
Sent: Monday, November 06, 2000 11:32 PM
To: ccielab@groupstudy.com
Subject: IPX RIP - Can't see a remote site

I have the following:
            ______R2
          /
R1---<
          \______R3---------R4

IPX RIP is running. R1 sees everything. R2 sees only R1. R3 sees
everything but R2. R4 sees everything but R2. It looks like maybe a split
horizon issue but I know for IP, frame interfaces automatically disable
split except for p-to-p subint's. I can't find a split horizon command
under 'no ipx ?' or 'ipx router rip ?'. Originally, I had FR map statements
on R1s major Se int. I tried moving the config to a multipoint
subinterface. Still no luck. Anybody know whassup?

• Next message: Jack Heney: "IPSec Dynamic---Configs"
• Previous message: zhangxianqi: "ospf redis"
• Maybe in reply to: Ronnie Royston: "IPX RIP - Can't see a remote site"
• Next in thread: Jack Heney: "Re: IPX RIP - Can't see a remote site"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:42 GMT-3