From: Wu,Jiang (wujiang@xxxxxxxxx)
Date: Tue Nov 07 2000 - 11:55:12 GMT-3
Configure R1 to run RIPv2 and send RIPv1 updates to R2. And the subnetwork betw
een R1 and R2 should not be same as R1's e0. Remember that RIP will auto summur
ize at network boundary?
Regards,
Wu
----- Original Message -----
From: Sam Munzani <sam@munzani.com>
To: Wu,Jiang <wujiang@bj163.com>; Daniel Keller <DMKeller@comdisco.com>
Cc: <ccielab@groupstudy.com>
Sent: Tuesday, November 07, 2000 10:39 PM
Subject: Re: RIP summary routes?
> But will it send summary route? Here is my ASCII drawing.
>
> 172.16.10.0/24--(e0)R1(e1)----172.16.20.0/24----(e1)R2(e0)---
>
> If R1 and R2 are using RIP1. and you use "ip summary-route 172.16.0.0 mask
> 255.255.0.0" on E1 or R1, will it show up on R2? I tried and it doesn't.
> Because RIP1 doesn't have subnet mask in update so R1 will send out only /24
> networks to a /24 interface.
>
> If somebody have it working against the behavior of RIP1 please post configs
> and routing table.
>
> Sam
>
>
> > Set the router to send only RIPv1 updates, may need to apply a
> distribute-list.
> >
> > ----- Original Message -----
> > From: Daniel Keller <DMKeller@comdisco.com>
> > To: <ccielab@groupstudy.com>
> > Sent: Tuesday, November 07, 2000 10:20 AM
> > Subject: RIP summary routes?
> >
> >
> > >
> > > Is it possible to send a summary route to a neighbor? I have a practice
> lab that asks me to configure RIP to only unicast a summary route of
> 140.1.0.0 to a neighbor router. I have searced CCO and tried doing this
> with no luck. Is this even possible or is the author of the lab on drugs?
> > >
> > > DK
> > >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:42 GMT-3