From: Simon Baxter (Simon.Baxter@xxxxxxxxxxxxxx)
Date: Sat Nov 11 2000 - 03:08:11 GMT-3
Can anybody explaing why the following occurs?
I'm trying to filter zones from neighbor updates. I discovered this....
even with all interfaces shut down, adding a apple ACL entry adds a visable
zone!!!
R7#sh ip int brief
Interface IP-Address OK? Method Status
Protocol
Ethernet0 unassigned YES NVRAM administratively down
down
Ethernet1 unassigned YES NVRAM administratively down
down
Ethernet2 unassigned YES NVRAM administratively down
down
Ethernet3 unassigned YES NVRAM administratively down
down
Ethernet4 unassigned YES NVRAM administratively down
down
Ethernet5 unassigned YES NVRAM administratively down
down
Serial0 unassigned YES NVRAM administratively down
down
Serial1 unassigned YES NVRAM administratively down
down
TokenRing0 unassigned YES NVRAM administratively down
down
R7#sh access-li
AppleTalk access list 600:
deny zone CARY
deny zone BLOBBY
deny additional-zones
permit other-access
R7#sh app zo
Name Network(s)
R4R1
DURHAM
BLOBBY
CARY
Total of 4 zones
R7#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R7(config)#access-list 600 deny zo WHATTHEHELL
R7(config)#^Z
R7#sh app zo
Name Network(s)
R4R1
DURHAM
BLOBBY
WHATTHEHELL
CARY
Total of 5 zones
R7#
That's too weird!!!
Simon
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:44 GMT-3