From: Connary, Julie Ann (jconnary@xxxxxxxxx)
Date: Thu Nov 16 2000 - 11:51:03 GMT-3
Hi All,
researching out MD5 authentication for OSPF yields the following two methods:
ip ospf message-digest-key keyid md5 key (used under the interface)
area area-id authentication message-digest (used under "router ospf
<process-id>")
I am assuming that if an interface is a Frame-Relay with multiple
frame-relay map statements for spokes, that
MD5 authentication must also be used on ALL spokes?
Is there a way to just enable MD5 authentication to a particular neighbor
in a hub and spoke environment? I'm working
on a lab that says that I have to set up the hub with a physical interface
with frame-relay map statements to two spokes (all three routers in Area
0), and then it says to configure MD5 authentication to only one of the
spokes - I'm not sure this is possible.
Thanks,
Julie Ann
------------------------------------------------------------------------
Julie Ann Connary
| | Network Consulting Engineer
||| ||| Federal Support Program
.|||||. .|||||. 13635 Dulles Technology Drive,
Herndon VA 20171
.:|||||||||:.:|||||||||:. Pager: 1-888-642-0551
c i s c o S y s t e m s Email: jconnary@cisco.com
------------------------------------------------------------------------
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:45 GMT-3