From: Ronnie Royston (RonnieR@xxxxxxxxxxxxxxxxx)
Date: Fri Dec 08 2000 - 14:24:06 GMT-3
It appears to be working per the 'sho' commands but after the BRI is down
for a couple of minutes, the RIP snapshot route ages out of the route table
on the server side? Should I need to manipulate the RIP timers or is my
snapshot config wrong? Thanks.
SERVER SIDE:
interface BRI0
no ip address
no ip directed-broadcast
dialer pool-member 1
isdn switch-type basic-ni
isdn spid1 0835866201 8358662
isdn spid2 0835866401 8358664
!
interface Dialer0
ip address 17.255.255.6 255.255.255.252
no ip directed-broadcast
encapsulation ppp
dialer remote-name L1
dialer string 8358661
dialer string 8358663
dialer snapshot 1
dialer pool 1
dialer-group 1
snapshot server 5 dialer
ppp authentication chap
ppp multilink
L7#sho snapshot
Dialer0 is up, line protocol is upSnapshot server
Options: dialer support
Length of active period: 5 minutes
For ip address: 17.255.255.5
Current state: active, remaining time: 5 minutes
Connected dialer interface:
BRI0:1
CLIENT SIDE:
interface BRI0
ip address 17.255.255.5 255.255.255.252
encapsulation ppp
isdn spid1 0835866101 8358661
isdn spid2 0835866301 8358663
dialer map snapshot 1 name L7 broadcast 8358662
dialer map ip 17.255.255.6 name L7 broadcast 8358662
dialer-group 1
snapshot client 5 8 dialer
ppp authentication chap
!
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:26:00 GMT-3