From: Fred Ingham (fningham@xxxxxxxxxxxxxxxx)
Date: Thu Dec 21 2000 - 15:04:44 GMT-3
Really need to see configs. If you are using OSPF: Do debug ip ospf adj
to see process. Sh ip ospf int - check that network types the same at
both ends. Sh ip int brief - check that addresses are in same subnet
with same mask. Sh frame map -
check that there is an ip map with the broadcast parameter.
And reboot both routers.
Cheers, Fred.
Dan Skiptunas wrote:
>
> Hello,
> I am having a problem with a neighbor router not going to the full =
> state ,router is stuck in Init state , interface is configured for =
> point-to-multipoint on both ends and the remote is seeing hellos, the =
> remote shows "Init" and the host shows nothing. any ideas on how to find =
> problem ?
>
> Thank You,
> Dan Skiptunas
> Network Engineer
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:26:09 GMT-3