From: Stephen Masraum (masraum@xxxxxxxxxx)
Date: Sun Jan 14 2001 - 23:44:49 GMT-3
Nope, in many cases you can use maps or the "fram int" command, but it's
best to use the map statements for multipoint and the "fram int" commands
for ptp.
either dlci should work for the local map. I believe if you make 2 maps for
the local one for each dlci you'll get double responses for a local ping.
Can't say for sure since it's been eons since I experimented with this
stuff.
Steve
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Sam Pilot
Sent: Sunday, January 14, 2001 7:38 PM
To: 'CCIE_Lab Groupstudy List'
Subject: Re: Pinging a Local Multipoint Subinterface.
George/Stephen
Is that a hard and fast rule (ie frame-relay interface-dlci is used for
point-to-point links)
My config seems to be working ok except for the fact that I cannot ping my
local interface.
Also
If i want to ping the same local interface ie 172.168.111.1
Then what should my frame-relay map statement be ...which DLCI should I use?
Please advice
Sam
----- Original Message -----
From: "George Sas" <sas_s@ins.com>
To: "'Sam Pilot'" <sam_pilot@hotmail.com>; "'CCIE_Lab Groupstudy List'"
<ccielab@groupstudy.com>
Sent: Sunday, January 14, 2001 11:10 PM
Subject: RE: Pinging a Local Multipoint Subinterface.
> Use frame-relay map ip x.y.z.v dlci {broadcast}
> x.y.z.v=the ip ddress of the interface you want to ping
frame-relay interface-dlci is used for point-to-point links
> > Hope this helps
> George
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> Sam Pilot
> Sent: Sunday, January 14, 2001 4:47 PM
> To: 'CCIE_Lab Groupstudy List'
> Subject: Pinging a Local Multipoint Subinterface.
>
>
> Hello Friends
>
> I have configured a Frame Relay Multipoint subinterface on a Serial
> interface.
>
> What should I configure on the router so that I am able to Ping the ip
> address of that interface.
>
>
> This is my config
>
> interface Serial0.1 multipoint
> ip address 172.168.111.1 255.255.255.0
> frame-relay interface-dlci 503
> frame-relay interface-dlci 506
>
> 503 and 506 are the DLCI's pointing to my spoke Routers.
> I am able to ping my remote spokes.
>
> Regards
>
> Sam
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:29 GMT-3