From: Sam Munzani (sam@xxxxxxxxxxx)
Date: Thu Jan 18 2001 - 11:20:36 GMT-3
Thanks,
It worked. I was forgetting aaa commands for auth. Since SSH requires
username and password both, it would not work without AAA. Actually until
you type in aaa commands and generate rsa keys, it doesn't give you "ip ssh"
command options.
Thanks again,
Sam
> dont forget
>
> aaa new-model
>
> line vty 0 4
> transport input telnet ssh
>
>
> ----- Original Message -----
> From: "Aamir Waheed" <awaheed@cisco.com>
> To: "Sam Munzani" <sam@munzani.com>
> Cc: <ccielab@groupstudy.com>
> Sent: Wednesday, January 17, 2001 3:11 PM
> Subject: Re: SSH on CISCO 2600
>
>
> > Hi Sam,
> >
> > I think trying out a 3 des image within the T-train would be a good
> > option, i have seen problems with some of the IOS's you talked about,
> > Moreover SSH in Version 1 depends on the IOS that you are using. If you
> are
> > using a DES IOS, then you are only going to get 56bit encryption, if you
> > are using a 3DES image, then you could get either 56bit or 168bit
> > encryption.
> >
> > Hope this helps,
> > Regards,
> > Aamir
> >
> >
> > Sam Munzani wrote:
> >
> > > Hi Group,
> > >
> > > CCO Documents says that SSH is there on 2600 series platform and thay
=
> > > even have configuration guide for SSH. I was unable to get those "ip =
> > > ssh" commands on 2611 with following IOS.
> > >
> > > 12.1.5 ENTERPRISE/FW/IPSEC 56 and 12.1.5T ENTERPRISE/FW/IPSEC 56=20
> > >
> > > Any input on this?
> > >
> > > Sam
> > >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:34 GMT-3