From: Les Hardin (hardinl@xxxxxxx)
Date: Tue Jan 30 2001 - 16:50:50 GMT-3
Elver,
Add the command "ip ospf network point-to-point" under the loopback
interface. Then you may advertise it as you need.
HTH,
Les
At 02:35 PM 1/30/2001 -0500, Elver Sena wrote:
>Hi,
>
>I've been looking for an answer to this and I can't seem to find it. I =
>looked in the archives, Cisco website, Thomas book, ...
>
>I have a loopback with a mask of 32 and advertised on OSPF. All other =
>OSPF routers were able to see this unicast address and put it in the =
>routing table.
>
>I then changed the mask of the same loopback to 24, and made the =
>appropiate "network..." change in OSPF. No OSPF router is now putting =
>the loopback in the routing table but they do see the router link for =
>the loopback's network in the OSPF database (LSA Type 1).
>
>I once heard that to make OSPF advertise a network mask on a loopback =
>(other than 32) an additional command must be added. Does any one have =
>any ideas?
>
>Thanks,
>Elver
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:49 GMT-3