RE: RIP Question

From: Merrill, James D. (AIT) (jm8752@xxxxxxx)
Date: Wed Apr 04 2001 - 18:38:26 GMT-3

• Next message: BUI, TIN T (SBCSI): "NLSP and EIGRP"
• Previous message: Clifton Stewart: "RIP Question"
• Maybe in reply to: Clifton Stewart: "RIP Question"
• Next in thread: Roche-Kelly, Edmund B.: "RE: RIP Question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Try
router rip
Offset-list 11 out 5 e 0
Access-list 11 permit x.x.x.x
I believe this will do it. You may have to change the cost value to 4. I
can't remember if the receiving router adds one.

James D. Merrill
Systems Engineer
SBC DataComm

                -----Original Message-----
                From: sanjay [mailto:ccienxtyear@hotmail.com]
                Sent: Wednesday, April 04, 2001 4:00 PM
                To: ccielab@groupstudy.com
                Subject: RIP Question

                I have 2 routers connected back-to-back via ethernet. They
are both running
                RIP v1. R1 has a loopback interface also. The lab I am
working on is asking me
                to configure R2 so that it sees the loopback with a hop
count of 5. I just
                can't seem to find any information on how to do this ??. Any
ideas.

                thanks,
                Sanjay

• Next message: BUI, TIN T (SBCSI): "NLSP and EIGRP"
• Previous message: Clifton Stewart: "RIP Question"
• Maybe in reply to: Clifton Stewart: "RIP Question"
• Next in thread: Roche-Kelly, Edmund B.: "RE: RIP Question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:40 GMT-3