From: Roger, Michael (Michael.Roger@xxxxxxxxxxxxx)
Date: Sun Apr 08 2001 - 15:31:49 GMT-3
It's a bug. Mine does the same but I live with it...Kinda funny when my
friends come over to do labs and I forget to tell them about it...
Mike
-----Original Message-----
From: Michelle Famiglietti [mailto:michelle@e-famiglietti.com]
Sent: Sunday, April 08, 2001 1:03 PM
To: ccielab@groupstudy.com
Subject: spid1 sent, spid1 not valid - but the line works???
Hello all.
I have an ISDN problem that has me stumped. Telco has tested the line,
confirmed the CO type, SPIDs, etc. I get this symptom with different
routers so I don't think it's a hardware problem.
Router is 2620 with integrated WIC-1BU running 12.0(7)T. The Central office
is AT&T 5ESS running National-1 ISDN. Router config excerpts:
username HOST password 0 test
isdn switch-type basic-ni
interface BRI0/0
ip address 192.168.182.27 255.255.255.0
no ip redirects
no ip directed-broadcast
encapsulation ppp
dialer map ip x.x.x.1 name HOST ##########
dialer-group 1
isdn switch-type basic-ni
isdn spid1 703#######0101 #######
isdn spid2 703#######0101 #######
ppp authentication chap
dialer-list 1 protocol ip permit
Here is the status of the BRI line:
#sh isdn sta
Global ISDN Switchtype = basic-ni
ISDN BRI0/0 interface
dsl 0, interface ISDN Switchtype = basic-ni
Layer 1 Status:
ACTIVE
Layer 2 Status:
TEI = 64, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
I_Queue_Len 0, UI_Queue_Len 0
TEI = 73, Ces = 2, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
I_Queue_Len 0, UI_Queue_Len 0
TEI 64, ces = 1, state = 8(established)
spid1 configured, spid1 sent, spid1 NOT valid
TEI 73, ces = 2, state = 8(established)
spid2 configured, spid2 sent, spid2 NOT valid
Layer 3 Status:
0 Active Layer 3 Call(s)
Activated dsl 0 CCBs = 0
The Free Channel Mask: 0x80000003
Total Allocated ISDN CCBs = 0
The line works both ways - I can send and receive calls. So why di I get
"spid1 not valid"?
Thanks,
Michelle
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:42 GMT-3