From: Daryl Wan Wai Meng (darylwan@xxxxxxxxxxxxxx)
Date: Tue May 08 2001 - 02:29:06 GMT-3
I think you should be using this instead...
r1(config)#dial-peer voice 1 voip
-----Original Message-----
From: Daniel C. Young
To: ccielab@groupstudy.com
Sent: 5/8/01 1:20 PM
Subject: "session target" command not working
Folks,
This is what I'm getting:
r1(config)#dial-peer voice 1 pots
r1(config-dial-peer)#session target ipv4:10.1.1.2
Incorrect format for Session Target
Must be of the form ^loopback:<compressed|uncompressed)$
I'm running 12.0.7T on the 2620. The IOS image is
c2600-js-mz.120-7.T.bin
(enterprise plus, I believe).
Any suggestions? Can't seem to locate this one on the cco.
Daniel Young
Sr. Network Engineer
Internet Data Center
SBC Service Inc. - ITO
(949) 221-1928 Office
(714) 350-8945 Cell
ICQ# 109846891
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:36 GMT-3