From: Jason Sinclair (sinclairj@xxxxxxxxxxxxxxx)
Date: Mon Sep 03 2001 - 21:27:30 GMT-3
Mike,
The output is correct as the interface (BVI 1) supports routing. What
topology are you trying to bridge over?
Could you please include a quick diagram?
Eg router-----------------router
For example if you are trying to bridge over f/r you will need to map the
bridging.
I need more details to help with this.
Cheers,
Jason Sinclair
Team Leader - NSG
POWERTEL Limited
Level 11, 55 Clarence Street, SYDNEY
Phone: 61-2-8264-3820
Mobile: 0416 105 858
jasons@powertel.net.au
-----Original Message-----
From: Mikael9495@aol.com [mailto:Mikael9495@aol.com]
Sent: Tuesday, 4 September 2001 10:36
To: sinclairj@powertel.com.au;
sinclairj@powertel.com.au; ccielab@groupstudy.com
Subject: RE: ISIS & IRB
my last post I incorrectly stated bridging twice for clns.
bridge 1 bridge clns
bridge 1 route clns
sh int bvi 1
route ip clns
the command doesn't show bridging, I assume because it's on
by default, the bridging is shown under the bridge 1 configuration.
**********************************************************************
This email (including all attachments) is intended solely for the named
addressee. It is confidential and may contain commercially sensitive
information. If you receive it in error, please let us know by reply email,
delete it from your system and destroy any copies.
This email is also subject to copyright. No part of it should be reproduced,
adapted or transmitted without the prior written consent of the copyright owner
.
Emails may be interfered with, may contain computer viruses or other defects
and may not be successfully replicated on other systems. We give no
warranties in relation to these matters. If you have any doubts about
the authenticity of an email purportedly sent by us, please contact us
immediately.
**********************************************************************
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:14 GMT-3