E1 via RJ45 or BNC

From: Murphy, Brennan (Brennan_Murphy@xxxxxxx)
Date: Fri Sep 07 2001 - 16:57:45 GMT-3

• Next message: @ Home NetMail: "Re: OSPF over Frame-Relay - Interface-DLCI vs. Map IP/Broadcas"
• Previous message: sanjay: "Re: OSPF over Frame-Relay - Interface-DLCI vs. Map IP/Broadcas"
• Next in thread: Barry Bocaner: "RE: E1 via RJ45 or BNC"
• Maybe reply: Barry Bocaner: "RE: E1 via RJ45 or BNC"
• Maybe reply: Tom Holloway: "RE: E1 via RJ45 or BNC"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Can a NM-4E1-IMA mate with an E1 received via BNC? Are there a couple
cables that would take you from RJ45--35pin-------35pin--BNC? Have
a circuit delivered via BNC but the pre-ordered hardware is RJ-45....
ouch. Any tips are much appreciated. I'm hoping I can avoid getting
a different NM if possible.
**Please read:http://www.groupstudy.com/list/posting.html

• Next message: @ Home NetMail: "Re: OSPF over Frame-Relay - Interface-DLCI vs. Map IP/Broadcas"
• Previous message: sanjay: "Re: OSPF over Frame-Relay - Interface-DLCI vs. Map IP/Broadcas"
• Next in thread: Barry Bocaner: "RE: E1 via RJ45 or BNC"
• Maybe reply: Barry Bocaner: "RE: E1 via RJ45 or BNC"
• Maybe reply: Tom Holloway: "RE: E1 via RJ45 or BNC"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:15 GMT-3