From: Ewing, James (james.ewing@xxxxxxxxx)
Date: Fri Oct 19 2001 - 09:27:35 GMT-3
Just don't forget to permit something ;)
James Ewing?
Network Engineer III- Network Architecture
One Digex Plaza
Beltsville, MD. 20705
? 240.264.2217 ?301.237.3566 ? mailto:james.ewing@digex.com
-----Original Message-----
From: Charles Demaret [mailto:cdemaret@flairdata.com]
Sent: Thursday, October 18, 2001 11:26 PM
To: Daniel Hong; ccielab@groupstudy.com
Subject: Re:
Try using an ACL to prevent ospf from initiating a call.
dialer-list 1 protocol ip list 101
access-list 101 deny ip any 224.0.0.5
----- Original Message -----
From: "Daniel Hong" <Daniel.Hong@nec.com.au>
To: <ccielab@groupstudy.com>
Sent: Thursday, October 18, 2001 10:04 PM
> Hi Groutp;
>
> I setup a ospf demond circuit , but the link will come up and stay up. I
turned on debug and found that BRI send a ospf multicasting traffic in every
40 seconds. This traffic keeped the link up.
>
> When I checked the dialer interface, there is a Pollinterval 40 second. I
searched cisco web site. couldn't find any info. Can some one shed me some
light.
>
>
> r6#sh ospf int bri 0/0
> BRI0/0 is up, line protocol is up (spoofing)
> Internet Address 172.168.65.1/24, Area 0
> Process ID 100, Router ID 172.168.255.6, Network Type POINT_TO_POINT,
Cost: 15
> 62
> Configured as demand circuit.
> Run as demand circuit.
> DoNotAge LSA allowed.
> Transmit Delay is 1 sec, State DOWN,
> Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
> Hello due in 00:00:01 (using PollInterval of
40)---------------------------<<<<?????
>
>
>
> Daniel Hong
> Master In Telecommunications, CCDP & CCNP+Voice
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 22:33:22 GMT-3