From: Thomas Larus (tlarus@xxxxxxx)
Date: Fri Oct 26 2001 - 11:22:47 GMT-3
First, your int bri0 on r7 is shutdown.
Second, you need a dialer-list 1 on r7 for your dialer-group 1 to use.
Third, you need a dialer-group and dialer-list on r6.
(Now I need to find out what "no ip neighbor-route" does.)
Best regards,
Thomas Larus
Original Message -----
From: <kevin@btamail.net.cn>
To: <ccielab@groupstudy.com>
Sent: Friday, October 26, 2001 9:25 AM
Subject: Ping doesn't work on isdn!!!
> Hello all, I config ppp multilink on router with isdn port. isnd
established successfully. But ping
> doesn't work. I debug ip packet. The following is shown:
> 02:06:31: IP: s=10.1.1.6 (local), d=10.1.1.7 (BRI0), len 100, sending
> 02:06:31: IP: s=10.1.1.6 (local), d=10.1.1.7 (BRI0), len 100,
encapsulation fail
> ed
> Two router configuration for isdn as following:
> r7#sh run int b0
> Building configuration...
> Current configuration:
> !
> interface BRI0
> ip address 10.1.1.7 255.255.255.0
> no ip directed-broadcast
> encapsulation ppp
> shutdown
> dialer idle-timeout 300
> dialer map ip 10.1.1.6 name r6 1111111
> dialer load-threshold 128 outbound
> dialer-group 1
> isdn switch-type basic-net3
> no peer neighbor-route
> ppp multilink
> end
> r6#sh run int b0
> Building configuration...
> Current configuration:
> !
> interface BRI0
> ip address 10.1.1.6 255.255.255.0
> no ip directed-broadcast
> encapsulation ppp
> dialer idle-timeout 300
> isdn switch-type basic-net3
> no peer neighbor-route
> ppp multilink
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 22:33:25 GMT-3