From: Brion Washington (CCIE6200@xxxxxxxx)
Date: Mon Nov 26 2001 - 04:39:09 GMT-3
The command used is
send * ---- this sends to all tty lines attached to term server
enable ---- to get into enable mode
config t ----- get into config mode
ip classless -- command you want to send
np ip http server ---- another command.
It is safe to send around 10 lines to the devices, do not send entire
configs (very messy). You can also use (send tty 3) to send commands just to
tty 3.
Brion
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Michael Popovich
Sent: Sunday, November 25, 2001 11:10 PM
To: ccielab@groupstudy.com
Subject: Send Command
I read in an earlier email someone talking about using the send command
to execute command lists through the TTY lines. I was under the
impression that the send command was used to just send messages. I took
a look at it again and all I can seem to do is send messages to the TTY
lines not Privilege Exec commands that allow me to configure the router.
I may have misunderstood what context the email was written in though.
If someone has info on this that I am not aware of I would be interested
in knowing.
Thanks in advance.
MP
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:22 GMT-3