From: Liu Jianxin-qch1927 (Jianxin.Liu@xxxxxxxxxxx)
Date: Fri Nov 30 2001 - 06:05:45 GMT-3
Do you use "backup interface" command on both side?
paste your config, maybe that can help us understand your problem.
-----Original Message-----
From: sliu@ttank.com [mailto:sliu@ttank.com]
Sent: Friday, November 30, 2001 4:06 PM
To: ccielab@groupstudy.com
Subject: A Dialer DDR Scenario
Router A and router B need to use dialer profile to backup a T1 link
between them.
When the T1 serial0 interface on rtr A goes down, and the dialer dials rtr
B, the call
got rejected with debug info showing "the dialer on rtr B is already in
standby mode
and can not take incoming call". Well, how would you configure the dialer
on rtr B
for it to take incoming calls from rtr A, if I do want the dialer on rtr B
to be a mutual
backup interface, which will put it into standby mode?
I've tried to create another dialer interface on rtr B, but when I typed in
dialer remote-
name rtrA, it complains that rtrA is already specified with the first
dialer on rtrB.
What do I need to do in order to setup this mutual dialer backup b/w rtrA
and rtrB?
Thank You!
- Sean
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:27 GMT-3