From: SFeldberg@xxxxxxxxxxxxx
Date: Mon Dec 03 2001 - 13:16:23 GMT-3
1) Auto-cost reference-bandwidth ## <cr> allows you to change the reference
bandwidth from 100Mbps to a value of ##. OSPF interfaces will then base
their cost calculation on this value. Auto-cost <cr> resets the value back
to 100Mbps.
2) Not really sure of the question. Syntax for using auto-cost is as
follows
router ospf 1
auto-cost reference-bandwidth 1000
interface Ethernet0
ip address 10.10.10.1 255.0.0.0
ip ospf cost 50
where the cost applied to the interface will override the auto-cost setting
for the E0 interface.
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/ip_r/ip
rprt2/1rdospf.htm#xtocid79697
Steve
Rajeev
Siddappa To: ccielab@groupstudy.com
<raj_lab@yahoo cc:
.com> Subject: Auto-Cost and OSPF
Sent by:
nobody@groupst
udy.com
12/01/2001
08:28 PM
Please respond
to Rajeev
Siddappa
1) What is the difference between
Auto-cost <cr>
and
Auto-cost reference-bandwidth <cr>
in OSPF process.
2) AND
Command " OSPF auto-cost " is correct or ( This does
not work but is listed in the configuration manual.
Command "Auto-cost reference-bandwidth"
Thnak you,
Rajeev.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:36 GMT-3