From: Emmanuel Oppong (e-oppong@xxxxxxxxx)
Date: Sat Feb 09 2002 - 18:43:15 GMT-3
You must have the old solution with that error. Here is the revised
solution for darth reid.
Enjoy.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Carl Phelan
Sent: Saturday, February 09, 2002 1:25 PM
To: ccielab@groupstudy.com
Subject: Solie - Darth Reid - Lab 2
Hi All,
In the 'Darth Reid' lab in Solie's CCIE practical Studies book, the
directions
are as follows:
'R1, R3 and R4 should share the same subnet. Configure OSPF Area 0 between
the routers; do not change the 'ip ospf network' type when configuring
OSPF'.
This to me says place these 3 routers in to OSPF area 0, right? Wrong! The
solution includes R2 in area 0 as well - although it is a member router of
the
frame, the directions as I read them imply that only the 3 routers stated
are
part of Area 0. I know that the instructions in the real lab itself can be
ambiguous and are open to interpretation but am I being unreasonable in my
interpretation of this instruction? Could the real lab possibly be as
ambiguous as this? I would appreciate your interpretation of this
instruction.
Many thanks,
Carl
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:17 GMT-3