From: RSiddappa@xxxxxxxxxx
Date: Sat Feb 23 2002 - 17:03:03 GMT-3
Mammmor,
I am little confused. Since R1 and R2 are alredy doing the briidng or DLSW
stuff.
I will take it like this, I need to connect two more routers at the end of
each side and cofifgure this on those as end systems right.
like this
R3------to---------R1-------so-----------R2-------To--------R4
R.
-----Original Message-----
From: Ahmed Mamoor Amimi [mailto:mamoor@ieee.org]
Sent: Saturday, February 23, 2002 10:06 AM
To: Siddappa, Rajeev; ccielab@groupstudy.com
Subject: Re: RSRB & DLSW+ (............)
DSPU will do the trick.
It is PU communicating with the host (mainframe). and that is non-routable
traffic of SNA.
on R1 : (simulate host)
dspu host test rmac xxxx.xxxx.xxxx lsap 6 dsap 6
where xxxx.xxxx.xxxx is the mac address of R2 to0
on interface To0
dspu enable-host lsap 6
dspu start test
on R2 : (simulate PU)
dspu PU test rmac xxxx.xxxx.xxxx lsap 6 dsap 6
where xxxx.xxxx.xxxx is the mac address of R1 to0
on interface To0
dspu enable-pu lsap 6
dspu start test
Now issue command for Dlsw,RSRB to see if the circuit is established if so
then ur config are correct as SNA
non-routable have seen each other.
for DSPU to check it have commnucated
show dspu
it will show u ACTIVE
U can also test bridges also this way.... beware of cononical to
non-cononical conversion.
-Mamoor
----- Original Message -----
From: <RSiddappa@NECBNS.com>
To: <ccielab@groupstudy.com>
Sent: Saturday, February 23, 2002 1:42 PM
Subject: RSRB & DLSW+ (............)
> I have following set up
>
>
> To-------R1----/(serial)/---------R2 --------To
>
>
> I do not have any end stations or any more token ring routers. How
> do I test the
>
> RSRB and DLSW in different modes. (FST,TCP, direct..)
>
>
> Thank you all in advance.
>
> R.
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:31 GMT-3