From: DAN DORTON (DHSTS68@xxxxxxxxxxxxxxx)
Date: Mon Apr 22 2002 - 17:23:04 GMT-3
I have a screwed up version of the code that will still bounce the circuit with
hellos no matter what you filter.
Of course this same version DLSW TCP does not work at all evern with the simpli
st configs.
It is 12.19TED I believe.
>>> "Lupi, Guy" <Guy.Lupi@eurekaggn.com> 04/22/02 02:42PM >>>
Try it without specifying the network type, ip ospf cost 9999 on both sides,
leave the hello interval at the default. From there, I would suggest
bringing the config down to basic OSPF, no authentication, area ranges, or
summary addresses. That way you can start adding things one by one and find
the command that introduces the instability.
~-----Original Message-----
~From: Tarek Sabry [mailto:tsabry@houston.sns.slb.com]
~Sent: Monday, April 22, 2002 3:29 PM
~To: Lupi, Guy; ccielab@groupstudy.com
~Subject: RE: Demand Circuit flapping
~
~
~Jim, Guy and all,
~
~Here .. I removed the dialer profile, removed IGRP, and
~basically removed
~almost every freaking thing.
~
~The multicast going from my BRI as source kicks in once the
~circuit goes
~down :(
~
~Thanks
~Tarek
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:17 GMT-3