about "linger" on dlsw backup peer

From: steven owen (trueccie@xxxxxxxxx)
Date: Wed Apr 24 2002 - 22:39:00 GMT-3

• Next message: steven owen: "how to control the dlsw circuit alive time"
• Previous message: Lupi, Guy: "ip route-cache"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
The following is got from CCO
"If the linger keyword is set to 0, all existing
sessions on the backup router immediately drop when
the primary recovers. If the linger keyword is
omitted, all existing sessions on the backup router
remain active (as long as the session is active) when
the primary recovers, however, all new sessions
establish via the primary peer."

But i found when i set "linger 0" or omit "linger",
the result is same ,i.e., all existing sessions on the
backup router immediately drop when the primary
recovers.

Thanks.

• Next message: steven owen: "how to control the dlsw circuit alive time"
• Previous message: Lupi, Guy: "ip route-cache"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:19 GMT-3