From: Phil (ciscostudent1@xxxxxxxxxxxx)
Date: Sun May 19 2002 - 06:53:58 GMT-3
This is the cable you4ll need:
http://www.anthonypanda.com/anthonypanda-CiscoCablesorEquivalent-DB50toDB60.htm
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=2025116239
Note that the DCE end is the DB60, so you4ll config the frame switch as usual b
ut the router end will provide the clock.
(If you have a 1005, its serial interface can4t provide clock).
Phil
John Underhill <stepnwlf@magma.ca> escreveu: I have one of these routers in m
y lab.. if you are planning to use this as a
frame switch to 25xx routers, you will need 4x DB50DCE to DB60DTE cables, as
the interfaces on this router are DB50.. Anthony has these as well, listed
as A special order on his page.. you may want to try symmic,
i_connectus@yahoo.com , or bob@router-rip.com all on ebay..
good luck
----- Original Message -----
From: "cash2001"
To:
Sent: Saturday, May 18, 2002 9:42 PM
Subject: Cabling for CCIE lab
> I am putting together my lab and I am unsure of one area. I am familiar
> with the DB60 to DB60 DTC/DCE cable and I know they function as a
> crossover cable.
>
> My question is can a Cisco DB60 to RS232 (DB25) Male function the same.
> A link to the cable is below as well as the device. Just wanted to
> clear the confusion before I drop the money.
>
> Link to cable:
> http://www.anthonypanda.com/anthonypanda-CiscoCablesorEquivalent-CiscoDB
> 60toRS232DB25Male.htm
>
> link to device:
> http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem
>
> &item=2024082765
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:59:01 GMT-3