From: Michael Popovich (m.popovich@xxxxxxxxx)
Date: Sun Jun 09 2002 - 17:49:02 GMT-3
What is the difference between this:
map-class frame-relay p2p
frame-relay cir 400000
frame-relay bc 8000
no frame-relay adaptive-shaping
Interface Se0/0.1
Access Target Byte Sustain Excess Interval Increment Adapt
VC List Rate Limit bits/int bits/int (ms) (bytes) Active
104 400000 1000 8000 0 20 1000 -
and this:
map-class frame-relay p2p
frame-relay traffic-rate 400000 408000
no frame-relay adaptive-shaping
Interface Se0/0.1
Access Target Byte Sustain Excess Interval Increment Adapt
VC List Rate Limit bits/int bits/int (ms) (bytes) Active
104 400000 7250 400000 8000 125 6250 -
I see some differences in the output but could someone explain the functional
differences here and what impact it would have.
I have been looking at some lab questions that require setting up traffic
shaping and give you a cir and a bir value. The solution used the frame-relay
traffic-rate under the map-class where as I was looking towards setting the
CIR and the Bc values. I am a little confused on the BIR value.
TIA
MP
This archive was generated by hypermail 2.1.4 : Tue Jul 02 2002 - 08:12:29 GMT-3