From: steven.j.nelson@xxxxxx
Date: Tue Jun 11 2002 - 03:54:29 GMT-3
Nick,
Try making you interface a sub using point to point, assuming of course you
are using the physical. If you are using protocol mapping, remember to put
the broadcast command on the end of the protocol ip command.
Thanks
HTH
STEVE
-----Original Message-----
From: Nick Shah [mailto:nshah@connect.com.au]
Sent: 11 June 2002 01:11
To: Ajay Sirohi; ccielab
Subject: Re: EIGRP Adjacency across ATM Cloud
Try, neighbor command under router eigrp.... (on both the ends).
rgds
Nick
----- Original Message -----
From: Ajay Sirohi <ccie@certworth.com>
To: <ccielab@groupstudy.com>
Sent: Tuesday, June 11, 2002 8:59 AM
Subject: EIGRP Adjacency across ATM Cloud
> I have an ATM attached local Router under my control ...
>
> I now have the challenge of forming EIGRP adjacency with another Cisco
Router
> across the service provider ATM Cloud.
>
> --------->>>
>
> I discover PVC parameters using LMI.
>
> I configure the VPI/VCI and map IP parameters.
>
> Vow !!! I can ping the other end right away.
>
> But no EIGRP adjacency in sight...... debug eigrp "x" does not bring any
> clue...
>
> What would you folks suggest ???
>
> Thanks,
>
> .............
> Certworth
> 3rd Try
This archive was generated by hypermail 2.1.4 : Tue Jul 02 2002 - 08:12:31 GMT-3