From: Michael Snyder (msnyder@xxxxxxxxxxxxxxxxxxxxxx)
Date: Tue Jul 16 2002 - 00:22:42 GMT-3
How do you modify the auto "Software MAC address filter" settings when
using bridging?
(1)------------------(2)------------------(3)
IPX ----HDLC-------Bridge--------HDLC-----IPX
332 IPX 332
I wanted to bridge ipx on the two serial interfaces on router 2, in
order to allow ipx network 332 on router 1 to pass ipx rip data to ipx
network 332 on router 3.
The best I can figure, the two ipx network interfaces can't find each
other over the serial bridge, because the ipx broadcasts are being
filtered out.
Which brings up a question, how do you modify the auto filter settings
when using bridging???
I tried a wide open access-list 700 applied to the serial interfaces,
but it didn't seem to help.
access-list 700 permit ffff.ffff.ffff 0000.0000.0000
access-list 700 permit 0000.0000.0000 ffff.ffff.ffff
-----------------------------------------------------------------
Router_2#show interfaces crb
Ethernet0
Loopback0
Routed protocols on Loopback0:
ip
Serial0
Routed protocols on Serial0:
ip
Bridged protocols on Serial0:
appletalk clns decnet vines
apollo ipx xns
Software MAC address filter on Serial0
Hash Len Address Matches Act Type
0x00: 0 ffff.ffff.ffff 0 RCV Physical broadcast
0x2A: 0 0900.2b01.0001 0 RCV DEC spanning tree
0x58: 0 0100.5e00.0006 0 RCV IP multicast
0x5B: 0 0100.5e00.0005 0 RCV IP multicast
0x5B: 0 0100.5e00.0005 0 RCV IP multicast
0xC0: 0 0100.0ccc.cccc 0 RCV CDP
0xC2: 0 0180.c200.0000 0 RCV IEEE spanning tree
0xC2: 1 0180.c200.0000 0 RCV IBM spanning tree
0xC2: 2 0100.0ccd.cdce 0 RCV VLAN Bridge STP
Serial1
Routed protocols on Serial1:
ip
Bridged protocols on Serial1:
appletalk clns decnet vines
apollo ipx xns
Software MAC address filter on Serial1
Hash Len Address Matches Act Type
0x00: 0 ffff.ffff.ffff 0 RCV Physical broadcast
0x2A: 0 0900.2b01.0001 0 RCV DEC spanning tree
0xA9: 0 00e0.1e5d.95b7 0 RCV Interface MAC address
0xC0: 0 0100.0ccc.cccc 0 RCV CDP
0xC2: 0 0180.c200.0000 0 RCV IEEE spanning tree
0xC2: 1 0180.c200.0000 0 RCV IBM spanning tree
0xC2: 2 0100.0ccd.cdce 0 RCV VLAN Bridge STP
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:36:31 GMT-3