From: William lu (mailluw@xxxxxxxxx)
Date: Sat Aug 10 2002 - 22:22:15 GMT-3
Hi,
I would use both technique complete this scenario:
1. Use CAR to limit the bandwidth used in CBWFQ. The
default bandwidth of physical interface be used for
the bandwidth calculation if you did not use TS or
CAR. (You may no be able to use bandwidth interface
command, which use for metric only).
2. Use CBWFQ to assign the bandwidth to each type of
traffic, which specify by CAR.
This is my implementation of the question. hope have
better one.
LUW.
Akhilesh, Where can I find this lab scenario? I'd like
to play with this completed lab.
--- Akhilesh Verma <akverma@cisco.com> wrote:
> Folks,
> I am working on Routopia LAB 3
and
> I have the following
> question
>
> Configure the serial interface on R6 so that Ping
> traffic can only
> utilize 10% of available bandwidth. Allow BGP to
> utilize no more
> than 20% of available bandwidth. Allow all other
> traffic to utilize up
> to 70% of available link capacity.
>
>
> Now ordinarily One would think that this is
> classification and not
> policing . Would you do CBWFQ here or CAR ?
>
> TIA
>
> Akhilesh
> ------------------------------------------------
> ------------------------------------------------
> Akhilesh Verma,
> Cisco Systems Inc.
> Systems Engineer
> 771,Alder Drive,
> Milpitas,CA-95035
> Pager:800-365-4578
> Direct: 408-853-9033
> Mobile: 510-501-1182.
> E-mail: akverma@cisco.com
>
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:48:22 GMT-3