From: Liban.Mohamed@mail.sprint.com
Date: Wed Sep 04 2002 - 11:47:47 GMT-3
Hi,,
this is what i found according to cisco...hope it helps.. that is why i
like GSR better u can reload the LC only.
1. %CBUS-3-OUTHUNG: [chars]: tx[char] output hung ([hex] - [chars]),
[chars]
A transmission attempt on an interface has failed. The interface might
not be attached to a cable or there might be a software problem.
Liban Mohamed
IP Engineer
Sprintlink Internet Backbone Operation
-----Original Message-----
From: ray.armstrong [mailto:ray.armstrong@data-evolution.net]
Sent: Wednesday, September 04, 2002 5:10 AM
To: ccielab
Subject: Problem Error Message.
Hi,
Anyone have any ideas why the FSIP in my 7010, would report this error
message ?
01:23:27: %CBUS-3-OUTHUNG: Serial0/5: tx0 output hung (800E - queue
full),
interface
01:23:28: %CBUS-3-OUTHUNG: Serial0/4: tx0 output hung (800E - queue
full),
interface
The serial interfaces are then rendered useless, unless you reload or
clear
the interfaces.
This problem occurs intermittantly from 10 minutes up to 1 hour before
it
happens, but it always does.
Extract from Sh Ver follows.
IOS (tm) 7000 Software (C7000-JS-M), Version 11.2(12), RELEASE SOFTWARE
(fc1)
any offers ?
rgds,
RA.
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:43:44 GMT-3