From: Logan, Harold (loganh@mccfl.edu)
Date: Thu Sep 12 2002 - 15:47:51 GMT-3
Try doing 'ip ospf network point-to-point' on the loopback interface.
hth,
Hal
-----Original Message-----
From: James [mailto:kang_z@hotmail.com]
Sent: Thu 9/12/2002 1:48 PM
To: ccielab@groupstudy.com
Cc:
Subject: subnet mask for ospf loopback interface
hi, everyone
when impletminting the NAT, "Practical study" said i could creat a loopback
interface as anchor to make sure the outside local address reachable.
my config is as follow:
inter loopback 1
ip addr 10.1.1.1 255.255.255.0
router ospf 1
net 10.0.0.0 0.0.0.255 area 0
i try to use loopback interface to represent the address range between
10.1.1.2 through 10.1.1.254.
but when i issue " show ip route", only 10.1.1.1/32 appeared, so that mean
10.1.1.x is still unreachalbe.
so could i generate a route about loopback interface with /24 mask if that
router is not a ABR and ASBR (no static route is allowed)
thanks
james
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:43:50 GMT-3