From: Prakash H Somani (pdsccie@rediffmail.com)
Date: Tue Sep 17 2002 - 11:03:03 GMT-3
Hi,
Actually in second u should use "Pass-throu" as it will pass
through the local ack.
It will work on both side P-T-M or both side physical interface.
regards....Prakash
On Tue, 17 Sep 2002 Donny MATEO wrote :
>Hi Group,
>
>I need help to clarify what is the difference between these two
>configs for DLSW direct
>encapsulation :
>
>dlsw remote-peer 0 frame-relay interface serial 0
>int s0
> frame-relay map llc2 131
>
>and
>
>dlsw remote-peer 0 frame-relay interface serial 0 131
>int s0
> frame-relay map dlsw 131
>
>Solie says to use the latter for a multipoint interface. I tried
>the latter, but the state seems to
>stay at disconnect. If I add the statement frame-relay map llc2
>131, then it would become connect.
>
>Any clue ?
>
>tks.
>Donny
>
>
>
>This message is for information purposes only and its content
>should not be construed as an offer, or solicitation of an
>offer,
>to buy or sell any banking or financial instruments or services
>and no representation or warranty is given in respect of its
>accuracy, completeness or fairness. The material is subject
>to change without notice. You should take your own independent
>tax, legal and other professional advice in respect of the
>content
>of this message. This message may contain confidential or
>legally privileged material and may not be copied,
>redistributed
>or published (in whole or in part) without our prior written
>consent.
>This email may have been intercepted, partially destroyed,
>arrive late, incomplete or contain viruses and no liability is
>accepted by any member of the Credit Agricole Indosuez group
>as a result. If you are not the intended recipient of this
>message,
>please immediately notify the sender and delete this message
> from your computer.
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:43:54 GMT-3