From: Raj Thava[IPC_Head Office] (traj@ipcc.ca)
Date: Tue Sep 17 2002 - 17:03:29 GMT-3
if you wnt to onfigure ipx tunnel over ip thent first make sure you have
connectivity between the routers using ip then
R1
interface tunnel 0
tunnel source - - - -
tinnel destination - - - -
ipx ipxwan 0 unnumbered R1
R3
tunnel source - - - -
tinnel destination - - - -
ipx ipxwan 0 unnumbered R3
This will connect R1 and R3 through the ipx
Raj
-----Original Message-----
From: Peng Zheng [mailto:zpnist@yahoo.com]
Sent: September 17, 2002 3:47 PM
To: ccielab@groupstudy.com
Subject: IPX config
Hi,
Below is the senario:
R1-----R2-----R3---(others)
The requirement is:
Not run IPX on R2.
R1 use R3 as default route.
R1 need to propogate a IPX network to R3 and other
network.
R1, R2, R3 have IP connection.
How should it be implemented?
I think it should be done by tunnel, but I can't
figure out how to config?
Thanks for help.
Best Wishes,
Peng Zheng
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:43:54 GMT-3