From: Peng Zheng (zpnist@yahoo.com)
Date: Tue Sep 17 2002 - 19:25:38 GMT-3
What about these two requirement?
R1 use R3 as default route.
R1 need to propogate a IPX network to R3 and other
network.
--- "Raj Thava[IPC_Head Office]" <traj@ipcc.ca> wrote:
> if you wnt to onfigure ipx tunnel over ip thent
> first make sure you have
> connectivity between the routers using ip then
>
> R1
>
> interface tunnel 0
> tunnel source - - - -
> tinnel destination - - - -
> ipx ipxwan 0 unnumbered R1
>
>
> R3
>
> tunnel source - - - -
> tinnel destination - - - -
> ipx ipxwan 0 unnumbered R3
>
> This will connect R1 and R3 through the ipx
>
> Raj
>
> -----Original Message-----
> From: Peng Zheng [mailto:zpnist@yahoo.com]
> Sent: September 17, 2002 3:47 PM
> To: ccielab@groupstudy.com
> Subject: IPX config
>
>
> Hi,
>
> Below is the senario:
>
> R1-----R2-----R3---(others)
>
> The requirement is:
>
> Not run IPX on R2.
>
> R1 use R3 as default route.
>
> R1 need to propogate a IPX network to R3 and other
> network.
>
> R1, R2, R3 have IP connection.
>
> How should it be implemented?
>
> I think it should be done by tunnel, but I can't
> figure out how to config?
>
> Thanks for help.
>
>
> Best Wishes,
> Peng Zheng
>
> __________________________________________________
> Do you Yahoo!?
> Yahoo! News - Today's headlines
> http://news.yahoo.com
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:43:54 GMT-3