From: Snow, Mark (Mark.Snow@newcome.com)
Date: Thu Sep 19 2002 - 01:49:07 GMT-3
Hey All,
Like always, I think that for all the complexites, I'm missing something
very basic!
Here's the deal ...
Per Solies lab "The Enchilada", when trying to redistribute OSPF Inter-Areas
into IGRP inside of R1 over to R5, I am getting all the OSPF routes on R5 to
show up, EXCEPT the ones which were in R2 Area 20, and R3 Area 30, and R7
Area 70. This means If I had Area 20 populated on that Eth segment with
network 155.100.21.0, then I see no .21.0 route on R5, but ALL the routes in
Area 0 show up. (Even my routes in my Virtual Link show up).
I even have all the Area range statements in the right routers.
So on R2, I have "area 20 range 155.100.21.0 255.255.255.0", etc ...
(I have even looked at the answers and can't figure out my mistake)
I'm sure it's simple, so could someone point me in the right direction
before I swing at the pinata?
If you want configs, tell me, I'll post them.
Thanks,
Mark Snow
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:43:56 GMT-3