From: ying c (bf5tgh1@yahoo.com)
Date: Thu Sep 19 2002 - 11:55:22 GMT-3
Let's say we have two dial peers, one point to
129.9.1.1 and the other one point to 129.9.2.2. How do
you make it to call 129.9.2.2 when 129.9.1.1 is busy?
If 129.9.1.1 and 129.9.2.2 are in the hunt group, then
we probably can do it from that end. But we are trying
to do it from the calling side.
Can this be done?
--- DBL <dlittlewood@totalise.co.uk> wrote:
> you need a voip dial peer
>
> example.
>
> dial-peer voice 3 voip
> destination pattern 900
> session target ipv4:129.9.1.1
>
> you need to have ip connectivity to the remote
> router to make and receive
> calls.
>
> ta.
>
>
> ----- Original Message -----
> From: "Voss, David" <dvoss@heidrick.com>
> To: <ccielab@groupstudy.com>
> Sent: Thursday, September 19, 2002 2:34 PM
> Subject: Voice Question
>
>
> > I am creating a voice lab and wish to create a
> VoIP session in the
> following
> > manner:
> >
> > Create a VoIP session to extension 900 via
> 129.9.1.1. If this phone is
> not
> > available, the session should then dial 129.9.2.2.
> >
> > Here is what I've done so far:
> >
> > dial-peer voice 1 pots
> > destination pattern 2222
> > port 2/0/0
> >
> > dial-peer voice 2 pots
> > destination pattern 3333
> > port 2/0/1
> >
> > Now, the problem... I don't have 129.9.x.x network
> in my routing tables,
> so
> > how am I supposed to create a call to these IP
> addresses? Should I used a
> > loopback or local port on my router?
> >
> > Also, not sure how to have a second IP address act
> as backup to the first.
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:43:57 GMT-3