From: Prakash H Somani (pdsccie@rediffmail.com)
Date: Sat Sep 21 2002 - 01:44:23 GMT-3
Hi Group,
One of my friend gave me following scenario which I m not able to
crack:
L0---R1---IP Network---------R8---L100
R1 Loopback address: 150.10.1.1
R1 Serial address: 150.10.100.1/24
R1 phone no is: 1111
R8 Loopback address:150.10.8.8 (There are multiple loopbacks on
this R8 routers and all the routes are available on R1)
R8 Serial address:150.10.80.1/24
R8 phone no is 8888
Now R8 config is not in my control. He has configured it and put
enable password.
He wants me to configure a Voip Dial-peer on my R1 router with
correct session-target address. (Where he has bind using
"h323-gateway voip bind srcaddr"
If I bind my VoiP dial-peer with serial interface as below:
#dial-peer voice 10 pots
destination-pattern 1111
port 1/0/0
#dial-peer voice 80 voip
destination-pattern 8888
session-target ipv4:150.10.80.1
I am getting one-way voice and distorted voice.....what he expects
is I should find out his Voip binding address....
IS this possible ??? I tried with all debug commands but not
getting any result....(He has gone on leave so not
contactable....)
Does anybody know solution?
regards....Prakash
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:43:59 GMT-3