From: Brian Dennis (brian@5g.net)
Date: Sun Sep 22 2002 - 19:16:56 GMT-3
The dialer-group with the dialer-list command is used to determine what
traffic will bring the line up and reset the idle-timeout. It doesn't
determine actually what traffic can go across the line once it's up.
Brian Dennis, CCIE #2210 (R&S/ISP Dial)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Dong Lin
Sent: Sunday, September 22, 2002 10:56 AM
To: ccielab@groupstudy.com
Subject: dialer-group question
The dialer-group is ONLY used to select interesting traffic to bring up
ISDN
line, or it is also used to decide which traffic can go through after
the
line is UP ?
In my test, I have the following:
access-list 104 permit icmp any any log
dialer-list 1 protocol ip list 104
After the line is up, I see all kinds IP traffic, like BGP, go through
the
line. Looks like dialer-group is ONLY used to bring up the line ?
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:44:00 GMT-3